PCB & PCBA Capability
PCB capabilities and PCBA capacity presented for faster technical evaluation.
Output, technical ranges, material options, assembly scope, and inspection resources are organized here to support engineering review and quotation decisions.
Capacity Numbers
Production figures that support PCB fabrication planning and PCBA scheduling.
Technical Coverage
PCB, FPC, aluminum PCB, assembly, and test capability in one technical overview.
PCB
2 to 28 layers
- Maximum processing area: 680 x 1000 mm
- Referenced thickness range from 0.3 mm to 6.5 mm
- Impedance tolerance listed up to +/-10%, minimum +/-5%
- Surface finishes include HASL, OSP, immersion gold, silver, tin, and gold connector
FPC
Fine-line flexible circuit support
- Single-sided and double-sided structures
- Line and space capability down to 1.2/1.2 mil
- Copper thickness options include 1 oz, 1/2 oz, 1/3 oz, and 1/4 oz
Aluminum PCB
Thermal structure and material performance for aluminum PCB projects.
Capability data includes peel strength, solder float, chemical resistance, heat transfer rate, thermal resistance, and dielectric voltage data, plus a structural drawing of copper clad, heat conducting, aluminum plate, and protective film.
PCBA
Assembly plus supply-chain coordination
- SMT, PTH, and BGA assembly
- Enclosure design support
- Quick prototyping and final assembly
- Custom clearance support for importing materials and exporting finished products
Testing
Inspection and validation equipment
- Universal tester and flying probe open/short tester
- High power microscope and solderability testing kit
- Peel strength tester and high volt open/short tester
- Cross-section molding kit with polisher
RFQ File Request
Core engineering files required for accurate PCB and PCBA quotation review.
Gerber files
Provide Gerber data for the bare PCB board.
BOM
Send the bill of materials for assembly projects.
Testing guide
Include test guidance and fixtures if they are required.
Programming support
Share programming files and tools when needed.
Schematic
Provide schematic information if it is necessary for the job.
Next Step
Technical review should move directly into RFQ action.
Once process fit is confirmed, upload Gerber, BOM, and project details to start quotation review.